© 2004,1996 BRUNO INDEPENDENT LIVING AIDS, INC.®
21
SRE-1540 UL 06-18-2004
INSTALLATION
[ ] Connect the wires as shown in the illustration. Tuck the excess wires in the footrest
hanger just above the footrest switch bracket, and below where the outer mounting
tube would sit. While holding the wires in place bring the footrest close to the
carriage, near the pivot bolt, tilt the footrest slightly while raising it up and over the
bolt until it is engaged in the slot. Tighten the bolt, then the (2) set screws at the top
of the footrest post (see illustration below) to completely secure the seat post.
INSTALLATION
pivot bolt
footrest switch bracket
footrest hanger
[ ] The footrest comes equipped with a safety switch which will stop the Elevator in
the event that something becomes trapped between the footrest and a stair tread.
[ ] Confirm correct operation of this feature by moving the sliding tray (BOTH
SIDES) while operating the Elevator. The Elevator will stop if this feature is
operating correctly.
footrest
safety switch
outer mounting
tube
INSTALLATION
FOOTREST ASSEMBLY - Residential and Commercial Units
BE CAREFUL NOT TO
PINCH
THE WIRES WHILE SLIDING
THE FOOTEST OVER THE BOLT.
NOTE:
SAFETY SWITCH - Residential and Commercial Units
set screws
