Bruker BioSpec 117 AVANCE III, Manual

Page: 40 / 102

40 ID: 182463115
Planning details
Measurements of the individual filter plates
Table 6.6: Measurements of the individual filter plates
6.2.1.1 Electronic filter plate
Position, alignment, and assembly
▪ In a horizontal position approx. 5 cm below the ceiling of the Faraday cage.
▪ The ideal position is on the wall adjacent to the technical room, as close as possible to the
service end of the magnet. If another position is selected, unnecessarily long cable lengths
must be anticipated.
▪ The electronic filter plate is assembled in an installation frame.
6.2.1.2 Magnet filter plate
Position, alignment, and assembly
▪ In a horizontal position approx. 5 cm below the ceiling of the Faraday cage. The magnet filter
plate is assembled directly beside the electronic filter plate.
▪ The ideal position is on the wall adjacent to the technical room, as close as possible to the
service end of the magnet. If another position is selected, unnecessarily long cable lengths
must be anticipated.
▪ The magnet filter plate is assembled in an installation frame.
6.2.1.3 Filter plate for anesthetic gas exhaust
Position, alignment, and assembly
▪ Beneath the ceiling of the Faraday cage
▪ The ideal position is directly above the service end of the magnet, above the CCM
If there are no detailed drawings for the filter plates described below, the measurements to be
used are those found in the following table.
Filter plate H B D B1 H1 B2 H2 B3 H3 C
[mm]
Electronics 410 1100 7 40 40 170 110 10 10 22
Magnet 220 450 7 45 50 120 120 7 7 22
Anesthetic gas ex-
traction 195 195 7 10 10 87,5 87,5 10 10 22
Magnet exhaust vent 260 260 6,5 10 10 80 80 10 10 22
MRI CryoProbe
TM
270 340 5 12,5 12,5 105 122,5 12,5 12,5 22
In-vivo
200 280 7 10 10 130 90 10 10 22
Ventilation See chapter
Abmessungen Kabinenbelüftung-Filterplatte [

42]