BRP Evinrude E-TEC Series, Service Manual, Page: 340 / 342

49 Air Temperature ABOVE range LED 3: OFF (Cranking) / ON (Running) 8 seconds Air temperature > 158° F (70° C).
51 Fuel injector circuit #1 OPEN LED 2: ON (Running) 8 seconds
Check injector/circuit resistance—2 to 3
Ω
@ 72°F (22°C).
52 Fuel injector circuit #2 OPEN LED 2: ON (Running) 8 seconds
57 High RPM with low TPS setting
3 3
LED 3: FLASHING 10 seconds
TPS < 5% and RPM > 3000. Engine SHUTDOWN. Will NOT restart until code has been cleared. The problem could be caused by uncontrolled fuel
entering the engine. DO NOT attempt to start the outboard until the problem has been found and repaired.
58 Operating temperature not reached LED 3: OFF (Cranking) / ON (Running) 9 minutes
Engine temperature < 104° F (40° C) with engine speed < 2300 RPM.
Check thermostat and pressure relief valve.
61 Fuel injector circuit #1 SHORTED LED 2: ON (Running) 8 seconds
Check injector/circuit resistance—2 to 3
Ω
@ 72°F (22°C).
62 Fuel injector circuit #2 SHORTED LED 2: ON (Running) 8 seconds
78 Sensor supply voltage fault
3
LED 3: OFF (Cranking) / ON (Running) 10 seconds Sensor voltage < 4.75 V. Check sensors and related wiring. Check for pinched or chafed wiring.
81 Ignition timing circuit #1 OPEN LED 2: ON (Running) 10 instances
EMM counts failed ignition events. Check wiring. Test with known good ignition coil.
82 Ignition timing circuit #2 OPEN LED 2: ON (Running) 10 instances
91 Fuel pump circuit OPEN LED 2: ON (Running) 8 seconds Check pump/circuit resistance—2 to 3
Ω
@ 77°F (25°C).
94 Fuel pump circuit SHORTED LED 2: ON (Running) 2 seconds Check pump/circuit resistance—2 to 3
Ω
@ 77°F (25°C).
101 Ignition timing circuit #1 SHORTED LED 2: ON (Running)
5 events-low speed
2 events-high speed
EMM counts failed ignition events. Check wiring. Test with known good ignition coil.
102 Ignition timing circuit #2 SHORTED LED 2: ON (Running)
5 events-low speed
2 events-high speed
117 Critical LOW OIL detected
3 3
LED 4: ON (Running) 6700 Pulses
EMM counts oil pump pulses after LOW OIL switch closes. Engine limited to 1200 RPM.
Stop outboard and add oil to tank. Warning resets after three oil pump pulses.
120 Oil level sensor OPEN
3
LED 4: ON (Running) 4 seconds Check switch continuity—open below 1/4 capacity, closed above 1/4 capacity.
NOTE: Always note service codes before clearing codes. Clear stored codes using diagnostic software. Clearing some codes requires turning EMM “OFF” and then “ON” again.
CODE
EMM CIRCUIT/SENSOR
INTERNAL
SENSOR
S.A.F
.E
SHUT
DOWN
EMM LED DISPLAY
TIME TO
ACTIVATE
SENSOR: CIRCUIT VOLTAGE / RESISTANCE (
Ω
) / INFORMATION
page 2 Rev 01/10