BRP Evinrude E-TEC Series, Service Manual, Page: 149 / 342

147
OILING SYSTEM
COMPONENTS
8
The oil manifold distributes the oil supplied by the
pump.
Electrical Circuit (55 V)
The oil injector is powered by the 55 V electrical
circuit. The
EMM controls pump operation by rap-
idly connecting and disconnecting the pump’s
internal coil to ground.
The EMM monitors the oil injection pump electri-
cal circuit. If circuit voltage is beyond the specified
range, or the circuit is open, the
EMM :
LOW OIL Warning
A switch in the oil tank assembly monitors the oil
level in the oil tank.
If the oil level falls below one-quarter capacity, the
EMM begins counting oil pump pulse cycles.
When it reaches 1000 pulses, the EMM signals:
Approximate oil reserve at Low Oil activation:
•
0.375 qt. (0.35 l).
NO OIL Warning
After LOW OIL is displayed, the EMM counts oil
pump pulse cycles again. When it reaches 6700
pulses, the
EMM :
To recover from S.A.F.E. mode:
•
Oil level must be above one-quarter
•
The warning resets after three oil pump pulse
cycles when the outboard has been stopped
and restarted.
If outboard has been run for more than 3 hours
with NO OIL faults (codes 34 & 117), the
EMM
1. Oil injector pump
2. Oil distribution manifold
3. Pickup tube and filter
007321
Activates S.A.F.E.
Stores a service code 34
EMM LED 4: ON (Running)
Engine Monitor LOW OIL display: ON
2
1
3
Engine Monitor LOW OIL display: ON
Activates S.A.F.E.
Stores service code 117
EMM LED 4: ON (Running)
Engine Monitor LOW OIL display: ON
Activates SHUTDOWN
Stores service code 33
EMM LED 4: FLASHING
Engine Monitor LOW OIL display: FLASHING