BRP Evinrude E-TEC Series, Service Manual, Page: 138 / 342

136
FUEL SYSTEM
FUEL COMPONENT SERVICING
Install Injector
The following items and their mating surfaces
must be cleaned prior to reassembly:
•
Injector
•
Cylinder head
•
Adapter
•
Screws
•
Threaded areas.
Lubricate mounting screw threads and under the
head of the screw with a light coat of
Triple-Guard
grease. Install washers (one per screw) on injec-
tor retaining screws.
Install screws and washers through mounting
flange of injector. Lower cylinder screws go
through the coil mounting bracket.
IMPORTANT:
Be careful not to pinch any wiring
during assembly.
Place injector and insulator in the proper cylinder
location.
Temporarily install injector screws finger tight.
Position fuel injector wiring, vapor separator wiring
and electrical connectors as shown.
IMPORTANT:
Fuel injectors MUST be able to
rotate slightly during installation of vapor separa-
tor.
Vapor Separator Installation
Install new injector seals in vapor separator.
Lightly lubricate seals with a drop of outboard
lubricant.
I
CAUTION
All injector components must be clean to
ensure correct torque tightening specifi-
cations. To prevent fuel leakage, carefully
follow these installation instructions.
007286
1. Fuel injector wiring and connectors
2. Vapor separator wiring
007100
1. Injector seals 007099
1
2
2
1