BRP Evinrude E-TEC Series, Service Manual, Page: 226 / 342

224
MIDSECTION
STERN BRACKET – MANUAL TILT MODELS
Install pin through each lock assembly and stern
bracket. Install washers and nuts, and tighten to a
torque of 18 to 20 ft. lbs. (24.5 to 27 N·m).
Apply Ultra Lock to the threads of the tie bar
screws. Install the screws and tighten to a torque
of 144 to 168 in. lbs. (16 to 19 N·m). Install the tilt
pin.
Tighten the tilt tube nuts to a torque of 40 to 45 ft.
lbs. (54 to 61 N·m), then back off 1/8 to 1/4 turn.
Install friction screw and spring in swivel bracket.
Apply a light coat of Triple-Guard grease to the
outside of the upper bushing.
Install upper bushing. Make sure bushing slots are
aligned with slots in swivel bracket.
Make sure friction plate is aligned toward friction
screw.
1. Pin
2. Nut and washer
007592
007591
1. Tie bar screws 007590
007589
2
1
1
1. Slots 007619
007620
1. Friction plate
2. Friction screw
007618
1
1
2
1