BRP Evinrude E-TEC Series, Service Manual, Page: 139 / 342

137
FUEL SYSTEM
FUEL COMPONENT SERVICING
7
Install vapor separator assembly onto the four fuel
injector fittings.
Install three vapor separator retaining screws.
Tighten two vapor separator to fuel injector mount-
ing screws to a torque of 29 to 48 in. lbs. (3.3 to
5.5 N·m).
IMPORTANT:
Fuel injector screws must be
tightened before vapor separator to powerhead
mounting screw.
Tighten injector screws in stages, starting with the
lower screw.
•
First torque is 4.5 ft. lbs. (6 N·m).
•
Second torque is 9 ft. lbs. (12.2 N·m).
•
Third torque is 14 ft. lbs. (19 N·m).
•
Final torque is 22 to 23.5 ft. lbs. (30 to 32 N·m).
Tighten vapor separator to powerhead mounting
screw to 29 to 48 in. lbs (3.3 to 5.5 N·m).
I
Install fuel supply hose. Secure with Oetiker
clamps. Reinstall vapor separator vent hose and
cooling water hoses. Secure with tie straps.
Attach fuel filter to vapor separator with tie strap.
I
Reinstall protective cap on the pressure test fit-
ting. Reconnect fuel injector electrical connectors.
1. Fuel injector fittings 007101
1. Vapor separator to fuel injector mounting screws
2. Vapor separator to powerhead mounting screw –
Leave LOOSE at this time
007102
1
1
1
2
Tighten Screws in Stages 007103
1. Vapor separator to powerhead mounting screw 007104
007287
1