BRP Evinrude E-TEC Series, Service Manual, Page: 238 / 342

236
MIDSECTION
TILLER HANDLE SERVICE
Apply Lubriplate to the ends of pin, guides, rollers,
helix grooves and inner handle guide slot. Place
the guides over the roller pin and into the slots of
the inner handle. Place the rollers on the ends of
the roller pin.
Assemble the helix halves on the handle and slide
the grip over the helix.
Carefully pull trim switch wires through inner tiller
handle as twist grip assembly is installed.
Be sure the twist-grip's speed indicator line is
positioned with the speed range symbol on the
handle. Snap the grip into place.
Place trim switch wiring under throttle cable as
shown.
Place Touch Troll wiring under throttle cable as
shown. Install touch troll switch bracket with three
screw. Tighten screws securely.
1. Roller 007557
007558
1. Trim switch wiring 007559
1
1
1. Indicator line 007481
1. Trim switch wiring 007560
1. Wiring
2. Throttle cable
3. Screws
007561
1
1
3
1
2