BRP E200DHLSEB, Service Manual

Page: 357 / 412

355
TRIM AND TILT
TRIM AND TILT SERVICE
14
Remove the rod from the vise. Use a small screw-
driver to carefully pry the scraper out of the end
cap. Discard the scraper.
Use a suitable tool to remove the inner quad-ring
and the outer O-ring. Discard the quad-ring and
O-ring.
Trim Rod Assembly
Lubricate and install a new quad-ring and scraper
in the end cap. Install a new scraper with the bevel
facing out. Lubricate and install a new O-ring on
the outside of the end cap.
Lubricate and install a new O-ring and two new
back-up rings on the trim rod piston. Place one
back-up ring on each side of the O-ring. Position
the open end of the back-up rings 180° apart.
Using Hydraulic Cylinder Rod Holder,
P/N 983213, clamp the rod tightly in a vise and
lubricate the cap and rod. Slide the end cap onto
the rod and install thrust pad. Tighten thrust pad to
a torque of 84 to 108 in. lbs. (9.5 to 12 N·m).
41843
41844
1. Bevel
2. O-ring
41845
1
2
1. O-ring
2. Back-up rings
41847
1. Thrust pad
41848
2 1
1