BRP E200DHLSEB, Service Manual

Page: 236 / 412

234
POWERHEAD
POWERHEAD ASSEMBLY
Lightly coat the outside diameter of a new crank-
shaft seal with
Gasket Sealing Compound
. Use
Seal Installation Tool, P/N 325453, to install seal
in lower crankcase head with extended lip of seal
facing down. Coat seal lips with
Triple-Guard
grease.
Lightly coat two new O-rings with
Gasket Sealing
Compound
and install on lower crankcase head.
Keep sealer away from oil passage.
Use threaded rods or Guide Rods, P/N 383175, to
align retainer plate with crankcase head. Slide
crankcase head onto crankshaft until seated
around lower main bearing.
Install new seals on the four bearing retainer
screws. Apply
Nut Lock
to the threads of the
screws and tighen to a torque of 96 to 120 in. lbs.
(11 to 13.5 N·m).
Lightly coat the outside diameter of a new upper
seal with
Gasket Sealing Compound
. Use the flat
end of Seal Installation Tool, P/N 325453, to install
seal flush in upper crankcase head with the lip
facing down. Coat the seal lip with
Triple-Guard
grease.
1. Seal, extended lip
DRC5798
1. Oil passage
004132
000826
1
1
000827
1. Seal installer, P/N 325453
49597
1