BRP E200DHLSEB, Service Manual

Page: 308 / 412

306
GEARCASE – STANDARD ROTATION
SHIFTER, BEARING AND SEAL SERVICING
groove is an oil passage. Gearcase damage could
result.
Apply
Gasket Sealing Compound
to metal casings
of new seals before installing.
Use Seal Installation Tool, P/N 330268 to install
new seals back to back in bearing housing. Install
inner seal with lip facing toward bearing housing,
then the outer seal with lip facing away from bear-
ing housing. Apply
Triple-Guard
grease to seal
lips.
Propeller Shaft Bearing Housing
Service
Rear Seal Removal
Remove seals using Puller Bridge, P/N 432127,
and Small Puller Jaws, P/N 432131. Position the
plate on top of the housing to support the bridge,
and tighten jaws securely behind the inner seal.
Bearing Removal
IMPORTANT:
Inspect bearings in place. If a
bearing is removed for any reason, it must be dis-
carded.
Remove either bearing using Puller Bridge,
P/N 432127, and Large Puller Jaws, P/N 432129.
Rest the puller plate on top of the housing to sup-
port the bridge, and tighten the jaws securely
behind the bearing.
1. O-ring (top groove)
2. Oil passage
006908
1. Inner seal
2. Outer seal
DR2061
DR2062
1
2
1
2
006895
006896