BRP E200DHLSEB, Service Manual

Page: 295 / 412

293
GEARCASE
WATER PUMP SERVICE
13
slide water pump down over key. Be sure impeller
key does not fall out of position.
IMPORTANT:
Make sure the impeller engages
the impeller key. Serious powerhead damage will
result if impeller key is not in place.
Align the impeller housing with the gearcase.
Apply
Gasket Sealing Compound
to threads of the
four impeller housing screws. Tighten the screws
to a torque of 60 to 84 in. lbs. (7 to 9.5 N·m).
On 20 in. outboard models, place Grommet,
P/N 349354, on housing cover.
On 25 in. and 30 in. outboard models, place the
appropriate water tube spacer and grommet on
the impeller housing cover.
After water pump is assembled completely, rotate
driveshaft counter clockwise 1/4 turn to unlock
and release impeller and key from driveshaft.
Next, pull up on driveshaft and turn clockwise to
lock impeller to shaft. This process increases
pump efficiency by locking the impeller in a slightly
lower position on the driveshaft.
IMPORTANT:
Before installing gearcase, shift
rod adjustment MUST be checked. Refer to
SHIFT ROD ADJUSTMENT
on p. 294.
1. Sharp edge of drive cam
2. Direction of driveshaft rotation
CO2995
1. Grommet
007150
2
1
1
1. Spacer
2. Grommet
32728
007078
2
1