BRP E200DHLSEB, Service Manual

Page: 100 / 412

98
ENGINE MANAGEMENT MODULE (EMM)
EXTERNAL SENSORS
If cylinder head temperature exceeds 194°F
(90°C) above 2000 RPM for 3 seconds, the
EMM
:
If cylinder head temperature exceeds 248°F
(120°C) for 3 seconds, the
EMM:
The outboard will not restart until the engine tem-
perature returns to normal. Refer to
SHUTDOWN
MODE
on p. 102.
If sensor values are less than -13°F (-25°C), or
greater than 329°F (165°C), the
EMM:
If sensor values are below -4°F (-20°C), the
EMM:
If cylinder head does not reach operating temper-
ature (122°F / 50°C below 1000 RPM) in 10 min-
utes, the
EMM
:
Shift Interrupt Switch
If the switch is stuck in the closed position, the
EMM:
Oil Pressure Sensor
The oil pressure sensor monitors oil pressure in
the oil distribution manifold.
If the sensor does not detect pressure for 150
pump cycles, the
EMM
:
If outboard has been run for more than 5 hours
with NO OIL faults (codes 34 & 38), the
EMM:
IMPORTANT:
The outboard will restart for
one
minute intervals
until problem is resolved and
code is cleared. To clear code use the diagnostic
software program.
If the sensor reads out of the expected range, or
the sensor or circuit fails, the
EMM
:
If the sensor circuit indicates below expected
range (<.4 V), the
EMM
:
If the sensor circuit indicates above expected
range (> 4.6 V), the
EMM
:
Activates
S.A.F.E.
Activates SHUTDOWN
Stores service code 31
EMM
LED 4: FLASHING
Engine Monitor TEMP display: FLASHING
Stores service code 41 (port sensor)
Stores service code 67 (stbd sensor)
EMM
LED 3: OFF (Cranking)
EMM
LED 3: ON (Running)
Stores service code 42 (port sensor)
Stores service code 68 (stbd sensor)
EMM
LED 3: OFF (Cranking)
EMM
LED 3: ON (Running)
Stores service code 58 (port sensor)
Stores service code 59 (stbd sensor)
EMM
LED 3: OFF (Cranking)
EMM
LED 3: ON (Running)
Stores service code 28
EMM
LED 3: ON (Running)
Activates
S.A.F.E.
Stores service code 38
EMM
LED 4: ON (Running)
Engine Monitor NO OIL display: ON
Activates SHUTDOWN
Stores a service code 33
EMM
LED 4: FLASHING
Engine Monitor NO OIL display: FLASHING
Stores service code 71
EMM
LED 3: ON (Running)
Stores service code 72
EMM
LED 3: ON (Running)
Stores service code 73
EMM
LED 3: ON (Running)