BRP E200DHLSEB, Service Manual

Page: 351 / 412

349
TRIM AND TILT
TRIM AND TILT SERVICE
14
Remove the three
Pozidriv
screws securing the
reservoir to cylinder body. Remove reservoir.
Remove the reservoir O-ring from the cylinder
body. Check the machined surfaces for nicks and
scratches.
Use a 6 mm hex wrench to remove the plug from
the cylinder body. Inspect the O-ring and the filter.
Replace, if necessary.
Remove the four screws securing motor to pump
manifold assembly.
Remove the wire shield from the pump manifold.
Remove the motor and inspect the motor O-ring
and the O-ring on the cable connector.
Remove and inspect the coupler. Remove the fil-
ter screen from the pump manifold. Check the
machined surfaces on the manifold for nicks and
scratches. The pump manifold is not serviceable.
Do not remove the pump or any control valves
from the manifold. Clean the screen with a mild
41753
1. O-ring
41759
41787
1
41760
22878