BRP E200DHLSEB, Service Manual

Page: 293 / 412

291
GEARCASE
WATER PUMP SERVICE
13
Assembly
Apply a drop of
Adhesive 847
in the seal ring
groove at each of the four ribs.
IMPORTANT:
Do not allow any adhesive to get
into the air bleed groove in the impeller housing. If
this groove is blocked by adhesive, the pump will
lose its prime and will not pump water.
Install the O-ring in impeller housing groove.
Lightly coat the exterior of the impeller cup with
Gasket Sealing Compound
. Install the cup in the
impeller housing.
Make sure vent hole in impeller cup is open.
On outboard models with 1/2 in. diameter water
tube, install the water tube grommet with the
inside taper facing up.
On outboard models with 5/8 in. diameter water
tube, apply a light coat of
Triple-Guard
grease to
the inside of the impeller housing water tube cav-
ity and to the water tube o-rings.
IMPORTANT:
Impeller Housing, P/N 5007968,
can be identified by a chamfer on the inside edge
of the water tube cavity.
On outboard models with 5/8 in. diameter water
tube, remove water tube from exhaust housing
and replace o-rings. Apply a light coat of
Triple-
1. Seal ring groove
2. Ribs
3. Air bleed groove
2311
DR1185
1. O-ring
34814
1
3
2
1
1. Water tube grommet
32000
1. Chamfer
32000
1
1
1
1