X7-8-Install-IG100 Installation Guide
Brocade
®
X7-8 Director Hardware Installation Guide
Table 14: Port Blade LED Descriptions
LED Purpose
Color
Status
Recommended Action
Steady green
The blade is operational.
No action is required.
Power
No light (LED is off)
The blade is not powered on.
Ensure that the blade is firmly
seated, with ejectors pushed in
fully to the center of the blade
and ensure that the captive
screw for each ejector is fully
tightened.
No light (LED is off)
The blade is either healthy or
does not have power.
Verify that the power LED is on.
Steady amber
The blade is faulty.
Ensure that the blade is firmly
seated and check the status
by entering the
slotShow
command. If LED remains
amber, consult the device
supplier.
Slow-flashing amber (on 1.28
seconds, then off 1.28 seconds)
The blade is not seated correctly
or is faulty.
Pull the blade out and reseat
it. If LED continues to flash,
replace the blade.
Status
Fast-flashing amber (on 320 ms
second, then off 320 ms)
Environmental range has been
exceeded.
Check for out-of-bounds
environmental conditions and
correct them.
Port has no incoming power, or
there is no light or signal carrier
detected.
Verify that the blade power LED
is on, check the transceiver and
cable.
Polling is in progress.
Allow 60 seconds for polling to
complete.
No light (LED is off)
The connected device is
configured in an offline state.
Verify the status of the
connected device.
Steady green
Port is online (connected to
an external device) but has no
traffic.
No action is required.
Slow-flashing green (on 1.28
second, then off 1.28 second)
Port is online but segmented,
indicating a loopback plug or
cable or an incompatible switch.
Verify that the correct device is
attached to the chassis.
Fast-flashing green (on 320 ms,
then off 320 ms)
Port is in internal loopback
(diagnostic).
No action is required.
Flickering green
Port is online, with traffic flowing
through the port.
No action is required.
Steady amber
Port is receiving light or signal
carrier, but it is not online yet.
Reset the port from
the workstation using
the
portEnable
or
portCfgPersistentEnable
command.
QSFP port Status
Slow-flashing amber (on 1.28
seconds, then off 1.28 seconds)
Port is disabled due
to diagnostic tests or
the
portDisable
or
portCfgPersistentEnable
commands.
Reset the port from
the workstation using
the
portDisable
or
portCfgPersistentEnable
command.
X7-8-Install-IG100
78
Broadcom
Summary of Contents for Brocade X7-8
Page 212: ......
