X7-8-Install-IG100 Installation Guide
Brocade
®
X7-8 Director Hardware Installation Guide
3. Enter the
sysShutdown
command. When command output indicates that the device has completed shut-down,
remove power cords from all power supply assemblies.
4. Remove defective WWN card assemblies using steps under
Removing the WWN Card and Bezel
, and then continue
with Step 5.
NOTE
There are two WWN card assemblies located behind the WWN bezel (logo plate). As you are facing the
bezel, WWN 1 is located on the left side, and WWN 2 is on the right.
5. Install replacement WWN card assemblies into the empty slot using the following steps:
a) Holding the card assembly by its edges with both hands along its length, slide it into the device slot.
b) Push with your thumb on the end of the assembly to fully seat into the backplane connector.
c) Use a No. 1 Phillips screwdriver to tighten the captive screw and secure the card assembly to the chassis.
NOTE
Be sure that the captive screws are tightened. If the captive screws have not been tightened, high
pressure from fan operation may unseat cards from chassis connectors.
6. Power on the device and wait for five minutes for the device to boot.
7. Verify that the new WWN cards are correctly connected by checking the LED functions. For details on LED operation,
see
.
NOTE
The LEDs may take up to two minutes after WWN card installation to begin functioning.
8. Resolve any issues flagged by RASlog EM-1220 and EM-1222 messages that display for the new card(s) before
proceeding.
NOTE
Issues relating to data recovery on new WWN cards must be resolved at this point before proceeding to
avoid invalid WWN data, errors, and operating problems.
9. Determine the active CP blade by entering the
haShow
command.
10. On the active CP blade, run the
wwnrecover
command and specify WWN 2 card for recovery when prompted in
wwnrecover
output messages. See
for more information on this command.
11. If
wwnrecover
messages prompt for a system reboot, reboot both CP blades to ensure that the system is running
with valid WWN card data.
12. Verify the new card settings by running the following commands and comparing the output with the original
supportsave
data:
•
chassisname
•
chassisshow
(look at the WWN and chassis information at the bottom)
•
ipaddrshow
•
licenseidshow
•
switchname
•
wwncardshow ipdata
13. Run the
switchcfgpersistentenable
command to persistently enable each logical switch that was disabled
before removing the WWN card(s):
switch:admin> switchcfgpersistentenable
Switch's persistent state set to 'enabled'
X7-8-Install-IG100
159
Broadcom
Summary of Contents for Brocade X7-8
Page 212: ......
