X7-8-Install-IG100 Installation Guide
Brocade
®
X7-8 Director Hardware Installation Guide
14. Install the WWN bezel on the chassis.
a) Orient the bezel on the chassis.
b) Insert and tighten both screws using a Phillips screwdriver.
15. Pack faulty WWN card assemblies in the packaging provided with the replacement cards, and return them to Brocade
Support for failure analysis (FA).
Removing the WWN Card and Bezel
Two WWN cards are located behind the WWN bezel. As you face the bezel on the nonport side of the device, WWN 1 is
located on the left side, and WWN 2 is on the right. When cards have been determined faulty and the replacement WWN
cards have been received, complete the following steps to remove the bezel and faulty WWN cards.
NOTE
Unless the device is powered down and not operational, do not perform these steps without first performing
procedures under either
.
1. Remove the two screws from the WWN bezel on the back of the device using a Phillips screwdriver. Pull the bezel
away from the chassis and set it aside. The ends of both WWN card assemblies with pull tabs are now visible.
2. Unscrew the captive screw for the WWN card assembly using a Phillips screwdriver until the assembly releases from
chassis.
3. Grasp the pull tab for a WWN card assembly and gently pull to release the assembly from backplane connector.
Carefully slide the card assembly out from the chassis slot.
Use both hands to support the card assembly along its length as you remove it from the slot.
Figure 50: Removing and Installing WWN Cards
1. WWN Card 1
2. WWN Card 2
3. WWN Card Bezel
X7-8-Install-IG100
160
Broadcom
Summary of Contents for Brocade X7-8
Page 212: ......
