X7-8-Install-IG100 Installation Guide
Brocade
®
X7-8 Director Hardware Installation Guide
3. Loosen the captive screw at each end of the fan assembly until the screw releases from the chassis. Use a No. 1
Phillips screwdriver if necessary.
4. Grasp the handle and pull, sliding the fan assembly from the chassis while supporting the fan assembly from beneath
as you remove it.
Figure 59: Removing and Installing a Fan Assembly
5. If you are leaving power on for replacement (hot-swap), be sure to replace the fan assembly as soon as possible.
Installing a Fan Assembly
Complete the following steps to replace the fan assembly in a chassis:
1. Grasp the handle and carefully slide the fan assembly into the chassis while supporting the fan assembly from
beneath.
2. Push the fan assembly fully into the slot with your fingers until it seats in the backplane connectors.
3. Verify that the power LED displays a green light.
4. Push in on each captive screw and tighten with a No. 1 Phillips screwdriver to secure the fan assembly to the chassis.
NOTE
Be sure that captive screws are tightened. If not, high pressure from fan operation may unseat fan from
chassis connectors.
X7-8-Install-IG100
177
Broadcom
Summary of Contents for Brocade X7-8
Page 212: ......
