X7-8-Install-IG100 Installation Guide
Brocade
®
X7-8 Director Hardware Installation Guide
{
{Switch WWN Flag Parm
10:00:00:05:1e:95:b1:00 0x00 0x200a00
Type number: SLKWRM
Model number: DCX
Manufacturer: BRD
Plant of Manufacture: CA
Sequence Number: 0AFX2533G001
tag: b6ff
}
5. Contact Brocade Technical Support for the replacement of WWN cards. Brocade support will request the partner or
OEM to send WWN cards from FRU inventory to the nearest Brocade Support office to be reprogrammed. Brocade
Support will require that the
Supportsave
data were taken in the previous step so that the replacement cards can be
reprogrammed prior to shipping to the partner or your site. If Brocade support has determined that both WWN cards
need replacing, you must replace both WWN cards as a matched pair.
Hot-Swap Replacement
You may replace one WWN card assembly at a time with the system powered on using the following steps to avoid
interruption of system operation.
Use this procedure if Brocade Customer Support has determined that a WWN card needs replaced and you have
received replacement cards. These procedures require that you use the
wwnrecover
utility.
1. Remove the defective WWN card assembly using procedures under
Removing the WWN Card and Bezel
Removing a WWN card assembly will result in RASlog messages indicating that a WWN card cannot be detected.
Since the system will be in a degraded state, replace the WWN card as soon as possible.
2. Install the replacement WWN card assembly into the empty slot using the following steps:
a) Holding the card assembly by its edges with both hands along its length, slide it into the chassis slot.
b) Push with your thumb on the end of the assembly to fully seat it into the backplane connector.
c) Use a Phillips screwdriver to tighten the captive screw and secure the card assembly to the chassis.
NOTE
Be sure that the captive screws are tightened. If they are not tightened, high pressure from fan operation
may unseat cards from chassis connectors.
3. Verify that the WWN card is correctly connected by noting if the LEDs on the card reflect the status of the components.
4. Address any issues flagged by any RASlog EM-1220 and EM-1222 messages that display for the new card before
proceeding.
NOTE
To avoid invalid WWN data, errors, and operating problems, issues relating to data recovery on new WWN
cards must be resolved at this point before proceeding. If EM-1220 messages indicate that IP addresses on
installed WWN cards do not match, follow instructions in the message to recover the IP address so that both
cards use the same address.
X7-8-Install-IG100
157
Broadcom
Summary of Contents for Brocade X7-8
Page 212: ......
