62
27. With the Belt Tensioning Screws and Brackets replaced, check the
walking belt tension. To check, pull the belt upward at it’s midpoint and
measure the distance to the deck. If the distance is more than an inch,
the belt is loose. To tighten, turn both bolts clockwise one-half a turn and
check tension again. Repeat this step if necessary. Be sure not to over-
tighten the belts.
28. Inspect the alignment of the Walking Belts. If the belt is tracking too
far on a side, turn the Belt Tensioning Screw on that side a full turn.
29. Plug in the fitness machine into an appropriately rated outlet.
Note:
The TC20 TreadClimber
®
fitness machine is designed to plug
directly into a properly wired and grounded three prong 120V outlet. If you
connect the machine to an outlet with GFI (ground fault interrupt) or AFI
(arc fault interrupt), machine operation can cause the circuit to trip.
30. Standing adjacent to the machine, turn on the belts and run at 1.5 mph
for about a minute.
31. Inspect the alignment. If necessary, continue to adjust the Belt Ten-
sioning Screw until aligned.
32. Final Inspection
Inspect your machine to ensure that all hardware is tight and components
are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner’s Manual.
