59
6. Using a #2 Phillips screwdriver, remove the 5 indicated screws
from the left Side Cover.
7. Using a 5 mm hex wrench, remove the lower mounting bolt from
the Cylinder. Leave it attached at the top.
8. Disconnect the Cylinder from the Treadle, and lower the Treadle
gently.
The Treadle will fall abruptly if not supported. Keep hands
away from the inside of the Treadles to avoid possible serious
injury.
9. Slide the Side Cover off of the machine.
10. Reconnect the Cylinder to the Treadle and re-install the lower
mounting bolt. Repeat the previous five steps to the right side of the
machine.
11. Using a #2 Phillips screwdriver, remove the 4 bolts holding the
Treadle Stop to the Left Treadle. There are two bolts on each side of
the Treadle.
12. Remove the Treadle Stop.
13. Remove the Drive Belt. Turn the Drive Pulley clockwise while
forcing the Drive Belt to the outside. Belt will come off of the Drive
and Motor Pulley.
Keep fingers out of any pinch opportunities when turning the
Pulleys.
Motor Pulley
Drive Pulley
