61
Left Rear Roller Bracket
Snap Ring
19. Using Cir-Clip Pliers, remove the Snap Ring from the Rear Roller
Assembly.
To avoid possible injury, be sure to wear eye protection before
removing the Snap Ring.
20. Using a 13 mm (1/2”) wrench and a 13 mm (1/2”) socket, remove
the 2 indicated bolts from the Left Side Bearing Plate.
21. Remove the Left Rear Roller Bracket from the Rear Roller.
22. Remove the lower Cylinder bolt using a 5 mm hex wrench.
23. Disconnect the Cylinder from the Treadle, and lower the Treadle
gently.
The Treadle will fall abruptly if not supported. Keep hands
away from the inside of the Treadles to avoid possible serious
injury.
24. Carefully slide the Walking Belt off of the deck.
25. Follow the same procedure for replacing the right Walking Belt.
26. Installation is the reverse procedure.
