69
21. Install the
IGUS (
“hat” shaped) bushings into the pivot arms.
22. Install the metal spacers/ washers into the bushings.
23. Add the washers to both sides of the Center Block as the bolt is installed.
Tighten only until the nut has bottomed out on the metal spacers/ washers.
Note:
Do not overtighten. Excessive tightening will cause the metal spacer to
crack.
24. Remaining assembly is the reverse procedure.
25. Installation is the reverse procedure.
26. Final Inspection
Inspect your machine to ensure that all hardware is tight and components are
properly assembled.
Do not use until the machine has been fully assembled and inspected
for correct performance in accordance with the Owner’s Manual.
