28
4. On the Motor Control Board, disconnect the Motor Power Wires by pulling straight out on
the Connectors – do not pull on the wire itself.
Note:
The Motor Control Board is located under the right Treadle.
AC Power
Wires
Motor Power Wires
Grounding Wire
MOTOR
POWER
WIRES
FAN
(not provided on newer
machines)
TACH
BLACK
RED
MOTOR CONTROL BOARD
WIRES
AC POWER
(I/O) CABLE
INPUT/ OUTPUT
5. Using a #2 Phillips screwdriver, detach the Grounding Wire from the Base As-
sembly. Push the loose wires through to the Motor compartment.
6. With assistance, carefully set the machine on to the right side.
Do not move the machine without aid. Injury to you or damage to the
machine can occur. The Treadles and Walking Belts can abruptly move.
To avoid possible serious injury, keep hands away from the inside of the
Treadles and the edges of the Walking Belts.
7. Remove the 4 indicated screws from the A/C Inlet housing using a #2 Phillips
screwdriver.
8. Remove the A/C Inlet, pulling the detached wires from the Control Board
compartment.
9. From the new A/C Inlet, push the Grounding and Motor Power Wires into the
Control Board compartment.
10. Attach the Motor Power Wires and the Grounding Wire to the Control Board.
11. Attach the new A/C Inlet using a #2 Phillips screwdriver.
Note:
Do not crimp any wires.
12. Attach the Motor Cover using the #2 Phillips screwdriver.
13. Attach the Rear Cover using the #2 Phillips screwdriver.
14. Final Inspection
Inspect your machine to ensure that all hardware is tight and components are
properly assembled.
Do not use until the machine has been fully assembled and inspected
for correct performance in accordance with the Owner’s Manual.
