48
21. With the Belt Tensioning Screws and Brackets replaced, check
the walking belt tension. To check, pull the belt upward at it’s mid-
point and measure the distance to the deck.
If the distance is more than an inch, the belt is loose. To tighten, turn
both bolts clockwise one-half a turn and check tension again. Repeat
this step if necessary. Be sure not to over-tighten the belts.
22. Inspect the alignment of the Walking Belts. If the belt is tracking
too far on a side, turn the Belt Tensioning Screw on that side a full
turn.
23. Plug in the fitness machine into an appropriately rated outlet.
Note:
The TC20 TreadClimber
®
fitness machine is designed to plug
directly into a properly wired and grounded three prong 120V outlet.
If you connect the machine to an outlet with GFI (ground fault inter-
rupt) or AFI (arc fault interrupt), machine operation can cause the
circuit to trip.
24. Standing adjacent to the machine, turn on the belts and run at 1.5
mph for about a minute.
25. Inspect the alignment. If necessary, continue to adjust the Belt
Tensioning Screw until aligned.
26. Final Inspection
Inspect your machine to ensure that all hardware is tight and compo-
nents are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner’s Manual.
