218
en | System menus and dialogs
Security Escort
2017.08 | V2.18.1.0 | DOC
Training Manual
Robert Bosch (SEA) Pte Ltd
Pager group
This is the group of up to 8 pagers that this message is to be sent to.
You may program the individual pager as well as a group of pagers.
The pager group will be sent the page before the individual.
Baud rate
This is the baud rate that will be used to communicate with the paging
computers. The paging company assigns this value.
System name
This identifies the Security Escort System when multiple Security
Escort Systems report to the same service pager. Keep this field as
short as reasonably possible since these characters, including space
character, will be sent before each trouble message and they are
included in the
Character limit
set above. If not desired, leave blank.
System phone
This will present phone number to be called in response to the service
page. Only use if required since these characters, plus a space, will be
sent before each trouble message. They are included with the
System
name
in the
Character limit
set above. If not desired, leave blank.
Send installer demo
alarms
If checked, demo alarms will be sent to the security pager.
Send all other alarms
If checked, all actual alarms will be sent to the security pager.
Security Pager Confm
Not Reqd
If checked, the confirmation pager message is not sent to the security
pager when the alarm is acknowledged by an acknowledgement
transmitter.
Cancel page If alarm
reset
If checked, the alarm page will be canceled if the alarm is reset before
it can be communicated to the paging service.
Send page a second
time, 2 minute delay
If checked an alarm page will be sent a second time to the security
pager. Do this in case the pager was in an area where pages could not
be heard when the first page was sent.
Do not resend alarm
page
If checked, a pager message is sent to the security person only once
till the alarm is cancelled or acknowledged.
Modem init
This is the initialization string sent to the modem to set it up for pager
communications. Normally, this setting would not have to be changed.
To allow changes to this string, hold down the <Shift> + <Ctrl> keys
when this dialog is first opened. This string is specific to each modem
model. The default setting should work with most modems.
[Save]
Save the changes and close the dialog window.
[Cancel]
Cancel the changes and close the dialog window.
8.3.11
Send pager message
Allows manually entered messages to be sent to the service or security pagers. Service and
security pagers are configured in the
Pager setup
dialog. Individuals and group pager
assignments are configured in the
Subscriber Database
.
