Bosch DOK-MOTOR-MCL Series, Project Planning Manual

Page: 27 / 196

4 Technical data
4.1 Explanations about technical data
4.1.1 Introduction
All relevant technical motor data as well as the functional principle of this mo‐
tors are given on the following pages in terms of tables and characteristic
curves. The following dependents are observed:
●
Frame size and frame length of the primary part
● Winding design primary part
● Available power connection or intermediate circuit voltage
All given data and characteristic curves are relating on the follow‐
ing conditions, if no others are specified:
●
Installation mode B acc. to fig. 11-29 " Motor force depend‐
end from the thermal connection" on page 150
● Keeping installation tolerances acc. to chapter 5.1 "Installa‐
tion tolerances" on page 47
● Keeping ambient temperatures acc. to chapter 9.3 "Setup
elevation and ambient conditions" on page 100
● Motor winding temperature ≤110 °C
Specified values in the data sheet are effective values according
to DIN EN 60034-1. Reference value is the maximum intermedi‐
ate circuit voltage of 420 V
DC
at MCP020 ... 070 or 48 V
DC
at
MCP015.
4.1.2 Operating behavior
The characteristic curve “force over speed” is specified as a characteristic
curve. The basic parameters and the run of the characteristic curve is defined
by the height of the intermediate circuit voltage and by the corresponding mo‐
tor specific data, like e.g. inductivity, resistance, force constant and so on. By
varying the intermediate circuit voltage (different controllers or supply mod‐
ules and connection voltages) and different motor windings result in different
characteristics result.
DOK-MOTOR*-MCL********-PR05-EN-P Bosch Rexroth AG 25/193
Rexroth IndraDyn L Ironless Linear Motors MCL
Technical data