Blohm + Voss Oil Tools FloorHand 9GF-1102, Technical Documentation Manual

Page: 27 / 105

27
OP
ER
AT
ION
S
27
OP
ER
AT
ION
S
Making a Connection
2. Once you have ensured that the op-
erating area is clear, pull the "Extend”
handle to move the FloorHand out to
the pipe. Release the "Extend” handle
when the tool approaches the pipe
center.
Figure 12
Figure 13
WARNING: BeFoRe opeRAtING the uNIt, mAke suRe thAt you hAve ReAd ANd uNdeRstANd thIs eNtIRe mANuAl
ANd hAve BeeN pRopeRly tRAINed IN the opeRAtIoN oF the uNIt. Also veRIFy thAt the uNIt hAs BeeN pRopeRly
INspected, Adjusted ANd luBRIcAted BeFoRe eAch use.
WARNING: AlWAys clAmp the loWeR WReNch BeFoRe clAmpING the uppeR WReNch oR spINNeR.
WARNING: do Not clAmp the FlooRhANd oNto the pIpe BeFoRe the pIN hAs BeeN stABBed.
1. Slowly pull the "Lift” handle to raise
the FloorHand approximately 2 to 3
feet from the rig floor.
Note:
RememBeR to AlWAys keep youR FRee hANd oN
the GReeN sAFety hANdle.
WARNING:
NeveR AlloW youRselF oR someoNe else to Be
BetWeeN the FlooRhANd ANd the pIpe, oR ANy
FIXed oBject.