Bioneer Exicycler 384, User Manual

Page: 24 / 78

19
www.bioneer.com
BQ-042-101-12
Revision : 0 (2018-07-05
Exicycler
™
384
Installing the Operation and Analysis Program
To run Exicycler ™ 384 Real-Time Quantitative Thermal Block, the operation software and the camera
driver must be installed in the computer. When installing the operation software and the camera driver
for the first time, or re-installing these components, please see instructions below on how to install
them yourself. In case of running the software for only data analysis purpose, please refer to this section
for software installation.
IMPORTANT:
Do not turn on
Exicycler
™384 unless you have installed the Operation and Analysis Program and a
camera driver. First install the Operation Software and then the camera driver.
To install Bioneer Package and Exicycler384 softwares for an
Exicycler
™ 384 device under Windows 7,
follow the instructions below:

If a previous version of software has been installed on your computer, please remove the programs
and folders from the computer (Refer to ‘Troubleshooting, 4. The Bioneer Package is not installed
correctly’). Remaining program folders may cause errors during installation. This section is for the
first time installation or re-installation of the software.

The Bioneer Package has to be installed prior to installing Exicycler384 software. The procedures of
Bioneer Package installation is described below.
Installing Bioneer Package
1) Turn on the computer, but not
Exicycler
™ 384 Real-Time
PCR machine. Place
Exicycler
™ 384 installation CD into the
CD-ROM. Go to ‘Bioneer Package’ folder in the CD drive
and run Setup.exe.
2) To install Bioneer Package, click Next. The installation will
proceed in C:\Bioneer_Package.