Bioneer Exicycler 384, User Manual

Page: 22 / 78

17
www.bioneer.com
BQ-042-101-12
Revision : 0 (2018-07-05
Exicycler
™
384
Overview
To run
Exicycler
™ 384 Real-Time Quantitative Thermal Block, camera driver and operation software
should be installed in a computer. When first installing the camera driver and operation software, or re-
installing these components, please see below for instructions on how to install them.
Site Requirements
Exicycler
™ 384 Real-Time Quantitative Thermal Block is for an indoor use. Ensure that the installation
site:
– Meets the spatial and weight requirements.
– Meets environmental requirements.
– (The instrument) Is within 1.5 m (4.92 ft) of a 800VA power receptacle.
– (The computer) Is within 1.5 m (4.92 ft) of a 500VA power receptacle.
– Is away from water.
Required Materials
Scissors, pocket knife, or box cutter
Unpacking
Exicycler™ 384
Save the packing materials and box in case you need to ship the instrument to Bioneer for service.
1) To unpack
Exicycler
™ 384:
a) Cut the straps securing the instrument box.
b) Cut the tape securing the top flaps of the instrument crate, then open
the flaps.
c) Remove
Exicycler
™ 384 accessories from the instrument and set them
aside.
d) Lift and remove the cover from the instrument crate.
e) Remove the packing material from Exicycler ™ 384, and then inspect
the instrument for shipping damage.
If
Exicycler
™ 384 is damaged, note location and appearance of the damage, and then contact Bioneer
Technical Support or your service representative.
2) Move Exicycler ™ 384 to the desired installation site. Follow these guidelines for lifting and moving:
– Make sure that you have a secure, comfortable grip.
– Keep your spine in a neutral position.