Bioneer Exicycler 384, User Manual

Page: 23 / 78

18
www.bioneer.com
BQ-042-101-12
Revision : 0 (2018-07-05
Exicycler
™
384
– Bend at the knees and lift with your legs.
– Do not lift and twist your torso at the same time.
3) Open the box containing
Exicycler
™ 384 accessories, then verify that it contains all the necessary
components:
– Refer to Component Lists.
Setting Up the Computer
Exicycler
™ 384 Real-Time Quantitative Thermal Block operates through a computer. Therefore, to install
Exicycler
™ 384, a computer or a laptop is necessary. Computer must meet the following requirements
listed below. Please contact Bioneer Customer Service Center if you have any questions regarding
installation.
Computer Requirements
– Intel Dual Core (1.8GHz) or higher
– Windows 7 & 10 Operating System for Korean or English Version (32/64 bit)
– 1.0GB RAM or higher
– 1280 * 1024 screen resolution
– USB 2.0 high speed port
– 20GB Hard disk drive minimum
– Microsoft Excel (Option)
For questions regarding problems with the computer or operating system, please contact the computer
manufacturer.
1) The computer must have at least one communication port for USB data transfer.
2) It is recommended to install an anti-virus software in order for
Exicycler ™ 384 to operate safely. A
firewall should also be setup to prevent unwanted information coming in from external networks.
Please contact your IT department to setup anti-virus software and firewall.
3) It is not recommended to insert a flash drive into USB port
Exicycler
™ 384 is running. It may cause a
technical problem between Exicycler ™ 384 and the computer.
Connecting the Computer and
Exicycler™ 384
There are main power connector and a communication port connector (USB) in the rear of Exicycler ™
384. The computer should be turned off when connecting to
Exicycler
™ 384 to prevent any damages to
the communication port. Please see below for instructions on how to connect Exicycler ™ 384 to the
computer.
1) Unpack
Exicycler
™ 384 and make sure all components are included.
2) Exicycler ™ 384 must be installed in an area where it is not exposed to sunlight and must be set on a
stable and level surface.
3) Set up the computer at the installation site.
4) Place
Exicycler
™ 384 in the installation site carefully.
5) Connect USB 2.0 cable to USB connector on the back of
Exicycler
™ 384, then to the computer.
6) Connect power cable to
Exicycler
™ 384, then to the receptable wall circuit.