AllInOneCycler
TM
/
Thermal Block
56
www.bioneer.com
BQ-042-101-01
Revision : 0(2012-12-07)
Error
Solution
It stops while operating.
1.
Check if power-supply to the instrument is on.
2.
Check if the Power switch has been pressed off.
3.
Check if you have pressed ‘Pause” by mistake.
4.
Request for Service.
The System is running but there
is an error.
1.
Check if wrong protocol has been used.
2.
Check if it is operating after rerunning the same program.
3.
Request for Service.
Temperature does not match
specified temperature
1.
Instrument may require calibration. Request for Service.
Cooling and heating rate too
slow.
1.
Request for Service.
There is a burning smell in the
system.
1.
Disconnect the power and unplug the power connector
immediately.
2.
Request for Service.
Hot-top cover not heated
1.
Request for Service.
Multi instrument use via PC
Error
Solution
The PC software does not
operate the instrument.
1.
Inspect the network cables connecting the PC and network
hub.
2.
Inspect the network cables connecting the instruments and
network hub.
3.
Verify that the network hub power is ON.
4.
Verify the PC network settings.
5.
Make sure the instrument control software is installed in
the correct folder.
6.
Request for service.
Instrument is not operating as
expected.
1.
Check to see if the ‘Run’ button was pressed more than
twice.
2.
Check to see if the software was executed twice.
3.
Restart the instrument and software.
4.
Request for service.
