AllInOneCycler
TM
/
Thermal Block
15
www.bioneer.com
BQ-042-101-01
Revision : 0(2012-12-07)
3)
Remove the
All
I
nOneCycler
TM
accessories from the instrument and set them aside.
4)
Lift and remove the cover from the instrument crate.
5)
Remove the packing material from the
All
I
nOneCycler
TM
, and then inspect the instrument
for shipping damage.
If the
All
I
nOneCycler
TM
is damaged, note the location and appearance of the damage, and then
contact Bioneer Technical Support or your service representative.
(2)
Move the
All
I
nOneCycler
TM
to the desired installation site. Follow these guidelines for lifting
and moving:
Make sure that you have a secure, comfortable grip.
Keep your spine in a neutral position.
Bend at the knees and lift with your legs.
Do not lift and twist your torso at the same time.
(3)
Open the box containing the
All
I
nOneCycler
TM
accessories, then verify that it contains:
All
I
nOneCycler
TM
Thermal Block User Guide
Power Cord, Power 10A/125V North America or Power 10A/220V Europe
4.
Setting Up the
All
I
nOneCycler
TM
(1)
Remove the packing material:
1)
Open the
All
I
nOneCycler
TM
hot-top cover.
2)
Using a can of compressed air, deliver a blast of air into each well of the bath block to
remove any particles that may have collected during transportation.
3)
Close the hot-top cover.
(2)
Connect the power cord to the
All
I
nOneCycler
TM
.
(3)
(Optional) Install any of the recommended protective devices.
(4)
Connect the power cord to the 700VA power source receptacle.
