AllInOneCycler
TM
/
Thermal Block
6
www.bioneer.com
BQ-042-101-01
Revision : 0(2012-12-07)
shock or fire.
(2)
Do not operate multiple instruments out of a single wall outlet. The load may cause
overheating and may lead to fire.
(3)
When plugging or unplugging the power cord from a wall outlet, make sure your hands are
completely dry. Wet or moist hands may cause electric shock.
(4)
A convenient and safe power cord should be available. The power cord provided by our
company should be used.
(5)
Socket outlets should be at least 1.5 m from a sink or wash basin.
(6)
Power cord cable should not be repaired with insulating tape. Water can still get inside.
(7)
If you use other power cord, it should be adequate for the electrical capacity for the
All
I
nOneCycler
TM
(250V, 16A, 0.75 mm
2
, VDE).
(8)
Plugs should match the socket outlets.
(9)
Unplug the power cord from the
All
I
nOneCycler
TM
when not in operation for a long period of
time to prevent the possibility of fire by overheating.
(10)
All
I
nOneCycler
TM
is equipped with a 3-conductor AC power cord that, when connected to an
appropriate AC power outlet, grounds (earths) the instrument. To preserve this protection
feature, do not operate the instrument from an AC power outlet that has no ground (earth)
connection.
(11)
Improper fuses or high-voltage supply can damage the instrument wiring system and cause a
fire. Before turning on the instrument, verify that the fuses are properly installed and that the
instrument voltage matches the power supply in your laboratory.
(12)
For continued protection against the risk of fire, replace fuses only with fuses (250V,F10AL,
2ea) of the type and rating specified for the instrument.
3.
Precautions regarding the operation environment
(1)
Avoid placing objects from every which direction the instrument.
(2)
Avoid installing the instrument in a dusty environment. Excessive dust may cause
malfunction or damage to the instrument.
(3)
Avoid installation near heat sources. This can cause fire.
(4)
Avoid installation near sources of water or damp locations. This can cause electrical shock,
fire or instrument malfunction.
(5)
Do not install near sources of flammable or corrosive gas. If there is a gas leak, do not
touch the power plug but open a window to circulate fresh air. Sparks from the power plug
can cause fire and explosions.
(6)
Do not disassemble or modify the instrument in any way. This can result in fire, electrical
shock or malfunction, and also voids your warranty.
