BECKWITH ELECTRIC M?3311A, Instruction Book

Page: 333 / 450

M‑3311A Instruction Book
6–54
IPSlogic (#1-6)
VOLTAGE INPUTS: As required
CURRENT INPUTS: As required
TEST SETTINGS: Time Delay D Cycles (1 to 65500)
Reset/Dropout Delay RD Cycles (0 to 65500)
Programmed Outputs Z OUT (1 to 8)
Expanded I/O (9 to 16)
Blocking Inputs (1 to 6)
Expanded I/O (7 to 18)
Output Initiate (1 to 8)
Expanded I/O (9 to 16)
Function Initiate (All Available Functions)
Initiate via Communication
Input Initiate (1 to 6)
Expanded I/O (7 to 18)
Block via Communication
1. Refer to Figure 4-58, IPSlogic, for logic gate configurations.
2. Select gate configuration (AND/OR) for Output Initiate, Function Initiate, Blocking Inputs and
Inputs Main.
3. Select Initiating Inputs for each gate (if AND gate is selected, ensure at least two outputs are
chosen). It will be necessary to enable and operate other functions to provide inputs for the
Function Initiate and Output Initiate gates.
4.
Pickup Test
: With output contact(s)
Z
connected to the timer, apply inputs to gates and start timing.
The operating time will be ( D ) cycles within

1 cycle or

1%, and the selected IPSlogic target
LED and the
OUTPUT
LED will illuminate or the pickup indicator will operate on the computer
target screen.
5.
Blocking Input Test
: To test the designated blocking inputs, press and hold the
TARGET RESET
button, then short input terminals designated as blocking inputs. The IPS LED will extinguish.
6. Repeat for each designated external triggering contact.
7. If testing is complete, enable any functions disabled for this test. If further testing is desired,
check the proper functions to disable for the next test and continue from this configuration.