BECKWITH ELECTRIC M?3311A, Instruction Book

Page: 81 / 450

M‑3311A Instruction Book
2–26
User Access Codes
To change the relay User Access Codes perform
the following:

NOTE : Communication must be established with
the target relay for this procedure.
1. From the IPScom
®
Main Screen menu
select
Tools/Security/Change User
Access Code . IPScom will display
the Access Level Code dialog screen
(Figure 2-24).
Figure 2‑24 Access Level Code Dialog Screen
2. Enter a valid Level 3 User Access Code,
then select OK . IPScom will display the
Change User Access Code dialog screen
(Figure 2-25).
Figure 2‑25 Change User Access Code Dialog Screen
3. Enter the desired New User Access Code
(1-9999), then re-enter (confirmation) the
New User Access Code.
4. Select Save , IPScom will display an
Access Code change Confirmation
Screen (Figure 2-22).
5. Select Yes , IPScom will display an
Access Code Was Changed Successfully
Confirmation Screen (Figure 2-23).
6. Select OK , IPScom will return to the Main
Screen.
System Error Codes, Output and Alarm Counters
The System Error Codes, Output and Alarm Coun-
ters feature provides the user with the ability to view
and clear system Error Codes, Processor Resets,
Alarm Counters, Power Loss Counter and Output
Counters. Also, Checksums can be viewed (IPScom)
for Calibration and Setpoints.
Clear Output Counters (Relay Front Panel)
To clear Output Counters from the Front Panel per-
form the following:
1. Press the
ENTER
pushbutton.
2. If Level Access is active, the following is
displayed:
ENTER ACCESS CODE
0
a. Input the required Access Code, then
press
ENTER
.
b. If the proper Access Code has been
entered, the HMI will return:
LEVEL #(1,2 or 3)
Access Granted!
VOLTAGE RELAY
VOLT curr freq v/hz
c. Go to Step 4.
3. If Level Access is not active, then the fol-
lowing is displayed:
VOLTAGE RELAY
VOLT curr freq v/hz
4. Press the Right arrow pushbutton until
the following is displayed:
SETUP UNIT
SETUP
5. Press ENTER, the following will be dis-
played:
SOFTWARE VERSION
VERS eth sn access