Baumer CiA DS-301, Manual

Page: 55 / 55

BUDE_Manual-CANopen_EN.doc 55/55 Baumer Hübner GmbH
MB703.E – 12A1 – Firmware version 1.0 P.O. Box 12 69 43 · D-10609 Berlin, Germany
23.10.2012 / bja Phone: +49 (0)30/69003-0 · Fax: +49 (0)30/69003-104
info@baumerhuebner.com · www.baumer.com
Technical modification reserved
6.1.5 Terminal assignment
Terminal Explanation
CAN_L CAN bus signal (dominant low)
CAN_H CAN bus signal (dominant high)
UB Supply voltage 10 - 30 VDC
GND Ground terminal for UB
Terminals with the same designation are internally interconnected.
•
Carefully plug the bus cover onto the D-SUB plug of the basic encoder/converter, then press only via the
sealing rubber, taking care not to tilt it. The bus cover must rest fully against the basic encoder/converter.
•
Tighten both the fastening screws firmly in the same direction.
The encoder housing/converter and braided shield of the connecting cable are only ideally connected if the
bus cover is resting fully on the basic encoder/converter (positive locking).
6.2 Display elements (status display)
A dual LED is integrated at the back of the bus cover.
LED green LED red Status
Off Off
Power supply not connected
Flashing Off Pre-operational mode
On Off Operational mode
On Off Stopped/Prepared mode
Off Flashing Warning
Off On Error