Barco XDL, Installation Manual

Page: 57 / 88

57 R5906150 /05 XDL
CAUTION: The electrical connection with the UPS INLET socket of the projector must be done with
a certified AC power supply cord (minimum 0,75 mm² or 18 AWG and minimum 300V)
CAUTION: Do not use the power OUTLET socket of the projector to provide power to other
equipment!
5.11 Lens installation
How to install a lens into the Lens Holder?
1. Remove the plastic cover in the opening of the Lens Holder if not removed yet. Place the Lens Holder in
the
“ unlocked ” position by moving the lens lock handle (reference 1 Image 5 – 20 ) to the right. Then, take
away the plastic cover.
1
Image 5 – 20
2. Take the lens assembly out of its packing material and remove the lens caps on both sides.
Caution: Do not touch the glass of the lens!
3. Ensure that the Lens Holder stands as good as in the On-Axis position (horizontal and vertical mid
position).
4. Place the Lens Holder in the “ locked ” position by moving the lens lock handle (reference 1 Image 5 – 21 ) to
the left, away from the lens power supply socket (reference 2 Image 5 – 21 ).
5. Gently insert the lens in such a way that the lens connector matches the socket. To prevent collision of the
lens ensure you center the lens and keep it on-axis while approaching.
Warning: Do not release the Lens yet, as the Lens may fall out of the Lens Holder.
6. Push the lens completely against the Lens Holder front plate. An audible click should be noticed. Once
seated, there may be no airgap between lens flange and Lens Holder front plate.
Caution: Ensure that the lock handle remains in the “ locked ” position.
Installation procedures