Barco XDL, Installation Manual

Page: 64 / 88

R5906150 /05 XDL 64
1
1
2
Image 5 – 30 Level alignment
When this is achieved, the projector is set horizontal and vertical at right angles to the screen.
S
C
R
E
E
N
S
C
R
E
E
N
Image 5 – 31 Angle adjustment
5.18 Installation of an input board
WARNING: The procedures below may only be performed by Barco trained and qualified
technicians.
CAUTION: Always wear a wrist band which is connected to the ground while handling the
electrostatic discharge (ESD) sensitive parts.
The procedure below is applicable to all the input modules of the Input & Communication Unit of the
projector.
Required tools
• Phillips screwdriver PH1
• Torx screwdriver T10
How to install
1. Switch off the projector and unplug the power cord of the projector.
2. If a dummy plate is mounted, remove the dummy plate. Release the 3 captive screws of the dummy plate
to remove it.
3
3. Push the input module in the Input & Communication module using the handles. Make sure the module
seats in its sliders (2).
Push the module until the contacts (3) are fully inserted into the connectors.
Installation procedures
3. Depending on the production date of the projector, the captive screws can either be Phillips screws or Torx screws. Refer to the tools
list to see what tool you may require.