Barco XDL, Installation Manual

Page: 60 / 88

R5906150 /05 XDL 60
3
Image 5 – 25
6. Close the U-bolt and tighten it.
Note: Make sure the safety cable is tightened around the lens before tightening the U-bolt nuts.
7. Place the shackle through the free loop end of the safety cable.
How to mount the cable
1. Make sure the transport protection bars are removed from the projector. Refer to “ Removing the transport
protection bars ” , page 47 .
2. Mount the lens safety cable bracket onto the projector frame. Mount it on the place where the transport
protection bar used to be. Use a 10 mm Allen wrench.
Image 5 – 26
3. Place the lens in the lens holder, using the lens locking mechanism.
Caution: Always make sure the lens is really secured by trying to pull the lens out of the lens
holder.
4. Snap the shackle through the fixation ring of the safety cable bracket.
5. Secure the shackle by screwing the safety ring of the shackle over the open end.
Installation procedures