Barco XDL, Installation Manual

Page: 58 / 88

R5906150 /05 XDL 58
1
2
C
l
i
c
k
Image 5 – 21
Note: For frequent installation and removal of the lens it is recommended to install the lens while
the lock handle is in “ open ” position (to the right) and put the lock handle in “ locked ” position
once the lens is inserted. Then check if the lens is properly installed by trying to pull the lens out
of the Lens Holder.
This alternative procedure results in less wear of the Lens Holder and reduces the risk of
accidentally moving the projector while pushing in the lens.
7. Check if the lens is really secured by trying to pull the lens out of the Lens Holder.
CAUTION: Never transport the projector with a lens mounted in the lens holder. Always remove the
lens before transporting the projector. Neglecting this can damage the lens holder and prism.
5.12 Lens safety cable
When using the safety cable ?
The lens safety cable must be used in any circumstances to protect a mounted lens in the lens holder when
the projector is mounted above persons.
Configuration differences
There are two different configurations for the safety cable. The configuration used depends on the used
carrying handle or hoisting eye.
• Configuration A applies when connecting the projector to the bottom carrying handle.
• Configuration B applies when connecting the projector to the top carrying handle.
Required tools
Allen wrench 10 mm
Required parts
• Safety Cable (750 mm, Ø3 mm)
• Cable clamp M4
• Shackle 7x70 mm
• 4 x Cable clip (16x16 mm, Ø4 mm)
• XDL safety cable bracket kit
How to mount the cable
1. Paste four cable clips on the lens as illustrated (reference 1). Orient the open side of the clips towards the
front of the lens.
Installation procedures