4. Installation
Projector
HUB
To LAN
DVI-D
COMPUTER
DVI-D
HDCP
COMPUTER
Image 4-22
Network connection
The port for ethernet communication is IP port 5401
The linking of projectors is treated in the section “Setup of the linked projectors in a multichannel system”
4.9.9.2
Network settings
C
AUTION
:
Make sure that a DHCP server is available in the network and works
fi
ne.
In normal conditions, the network detection takes few seconds. This means that the total time needed to go
from power ON to Standby mode is only a few seconds. This value can vary depending on the speed of the
network connection.
But when the DHCP setting of the projector is set to Yes and the network does not allow the projector to obtain
an IP address from the DHCP server, the startup time will be delayed by upto
fi
ve minutes. After this time, a
time-out occurs if the network detection fails, and the projector starts up without any network connection.
What can be done?
These settings are used to set the Ethernet Communication parameters.
Following parameters are available :
MAC Address
MAC Address of the projector (This is a non-adjustable value programmed into the Ethernet
board).
IP Address (Current)
IP Address of the projector (This is a non-adjustable value).
Subnet Mask
Subnet Mask (This is a non-adjustable value)
32
R59770324 SIM 5W 22/12/2011
Summary of Contents for SIM 5W
Page 1: ...SIM 5W User guide R59770324 06 22 12 2011 Downloaded From projector manual com Barco Manuals ...
Page 54: ...5 Setup 50 R59770324 SIM 5W 22 12 2011 Downloaded From projector manual com Barco Manuals ...
Page 194: ...Index 190 R59770324 SIM 5W 22 12 2011 Downloaded From projector manual com Barco Manuals ...
