Barco R92112011, User Manual

Page: 54 / 210

6. Getting started
6.3 Adjusting the image
How to adjust the image ?
1. Use the Image setting buttons on the RCU
AUT AUTO IMAGE O IMAGE
PC PC RGB RGB
VIDEO VIDEO
Fire W Fire Wire ire DVI DVI
IQ-PC IQ-PC SDI SDI
S-VIDEO S-VIDEO
PHASE PHASE
TINT TINT
COLOR COLOR
BRIGHTN BRIGHTN
CONTR CONTR
ZOOM ZOOM
DIGI DIGI
9 0
7 8
5 6
3 4
1 2
Image 6-3
6.4 Switching the projector to standby
Introduction
If the projector is not to be used for a period of time (hours, days), it is advised to switch it to standby to save energy or it can be
fully powered off after the cooling cycle. The advantage of standby mode compared to power off mode is the time to get it back to
active state (i.e. lamp on).
After switching the projector to standby, the lamp is switched off and the cooling cycle is started (two minutes). Do not power off
the projector during the cooling cycle since doing so reduces the lamp life time.
In case of SIM 7Q HB or SIM 7Q HB&C, the projector cannot be switched from active state to standby state within the fi rst two
minutes after it has been activated. Trying to do so pops up an alert message and the command is only executed after the two
minutes period has expired.
Image 6-4
Switching to standby
1. While the projector is in active state, keep the Standby button on the RCU or on the local keypad pressed for two seconds.
2. The lamp is switched off and the two minute cooling cycle is started.
50 R59770066 SIM 7Q SERIES 08/12/2014