Barco R92112011, User Manual

Page: 138 / 210

7. Advanced
W2 White Projector 2
Rc
Red Common Color Gamut
Gc Green Common Color Gamut
Bc
Blue Common Color Gamut
Wc White Common Color Gamut
The following parameters can be adjusted within DynaColor™:
•
the x, y coordinates and L (Light Output) of the 6 Common Color Gamut perimeter points.
• the x, y coordinates and L (Light Output) of the White point of the Common Color Gamut.
The Dynacolor™ Interface
Field / item Description
Measured values The coordinates in the CIE Chromaticity diagram and luminance of the native
primary colors of the projector as they have been measured in ideal conditions in
the factory. Only Barco engineers may change these values.
X and Y coordinates Coordinates in the CIE Chromaticity diagram
Red, Green, Blue, White Native primary colors and native white of the projector
L value Luminance (relative value)
White L White luminance = Red + Blue + Green luminance (relative value)
Desired values Description
Desired values The coordinates in the CIE Chromaticity diagram and luminance of the desired
primary and secondary colors of the projector. Only Barco engineers may
change these values to force a common color triangle; Barco trained and
quali
fi ed engineers may also change the X and Y coordinates of the white
point to fi ne tune the colors.
X and Y coordinates Coordinates in the CIE Chromaticity diagram
Red, Green, Blue, White Desired primary colors and desired white of the projector
Cyan, Yellow, Magenta Desired secondary colors of the projector
L value Luminance (relative value)
Lmax value Maximum available luminance (relative value)
Button Description
Default desired Uses the Measured parameters to calculate and fi ll out the Desired values.
In case of SIM 7Q HB or SIM 7Q HB&C, this command also sets the white point to
the default white point (x = 0.306, y = 0.382) to avoid the greenish perception of the
projector’s native white point.
Factory Preset Overwrites the Measured parameters by the factory measured values.
Maximum white (only available in case of SIM 7Q HB or SIM 7Q HB&C)
Uses the Measured parameters to calculate the Desired values without correction
for the white point. In this state, the white point is slightly greenish.
Calibration Starts the native primary color and native white color calibration procedure. Only
Barco engineers may perform a calibration. A professional spectrometer and
ideal measurement conditions are required to achieve a good calibration. Improper
calibration seriously affects the performance of the projector. See the SIM 7 service
manual for the detailed calibration procedure.
134 R59770066 SIM 7Q SERIES 08/12/2014