Barco R92112011, User Manual

Page: 35 / 210

4. Installation
HUB
To LAN
Image 4-37
Network connection through a HUB
See Network settings to set the communication port.
4.7.3.2 Network settings
C
AUTION
:
Make sure that a DHCP server is available in the network and works fi ne.
In normal conditions, the network detection takes few seconds. This means that the total time needed to go
from power ON to Standby mode is only a few seconds. This value can vary depending on the speed of the
network connection.
But when the DHCP setting of the projector is set to Yes and the network does not allow the projector to obtain
an IP address from the DHCP server, the startup time will be delayed by upto
fi ve minutes. After this time, a
time-out occurs if the network detection fails, and the projector starts up without any network connection.
What can be done?
These settings are used to set the Ethernet Communication parameters.
Following parameters are available :
MAC Address MAC Address of the projector (This is a non-adjustable value programmed into the Ethernet
board).
IP Address (Current) IP Address of the projector (This is a non-adjustable value).
Subnet Mask Subnet Mask (This is a non-adjustable value)
Gateway Gateway (This is a non-adjustable value)
R59770066 SIM 7Q SERIES 08/12/2014 31