Barco MCM-400 HFR, User Manual

Page: 101 / 214

9. Advanced operation
9.1.3 General geometry adjustment work fl ow
Performing geometry adjustment
1. Open the Geometry edit dialog for 2 x 2 mode. See "Selecting the geometry level ", page 100. The default selected anchor point
is the left top corner of the image.
2. If required, select another anchor point of this level. See "Selecting an anchor point", page 102.
3. Move the selected anchor point to the desired position. See "Moving an anchor point in small steps", page 104 and "Moving an
anchor point in large steps", page 105.
Note: Anchor points should only be moved inside the visible image area since moving an anchor point to the outside causes
loss of image content.
4. Select each of the other anchor points in this level in turn and move them to the desired position.
5. Then, select each of the anchor points of the next lower level in the selected geometry mode and adjust their position.
6. Repeat the previous step for all levels of the current geometry mode in turn.
7. If the geometry cannot be fully adjusted in the current mode, select the next lower geometry mode. See "Selecting the geometry
level ", page 100.
8. Repeat step 2 to step 7 until the geometry is fully adjusted to the speci fi cations.
R5909056 MCM-400 HFR 11/05/2016 97