Barco HDF-W30LP, User And Installation Manual

Page: 239 / 311

18. Projector Control
Image 18-33
Wireless default gateway, input
4. Use the ▲ or ▼ key to change the selected character.
Use the ◄ or ► key to select another character.
Note: Digits can be entered with the digit keys on the remote control or the local keypad. When a digit is entered in that way,
the next character will be selected automatically.
18.7 IR Control switching
What can be done ?
Each IR receiver inside the projector can be activated or deactivated. When an IR receiver is deactivated, no IR signal sent to this
IR receiver will be processed.
How to activate or deactivate
1. Press Menu on the remote control (RCU) or on the local keypad to activate the menus and select Projector Control → IR control .
2. Use the ▲ or ▼ key to select the desired IR control and press ENTER to check checkbox.
Checked : IR receiver is enabled and can receive and process commands sent by the remote control.
Not checked : IR receiver is disabled and not receive any command.
18.8 DMX
Overview
• DMX address
• DMX universe
• DMX mode
• Art-Net DMX
• Front XLR output voltage control
• Monitor
• DMX Shutdown
• DMX Shutdown retarding time
About the ways to control the projector via DMX
With a standard DMX cable equipped with XLR connector DMX signals can be connected to the DMX In port on the communicator
interface. The DMX out can be used to create a chain of DMX devices. One universe can control up to 512 channels.
If you are using a DMX console and other automated lighting products compatible with Art-Net, the Ethernet network can serve as
the link for DMX control. All DMX controls can be sent over the Ethernet cable. Multiple universes are possible.
R5906730 HDF WLP SERIES 01/08/2017 235