Barco HDF-W30LP, User And Installation Manual

Page: 201 / 311

17. Alignment
Yes: fi les will be deleted.
No: no fi les deleted
17.7.22 Warp board reset
What can be done?
In some circumstances the hardware of the warping get stuck. A hard reset of the board is the only solution. With Warp board reset,
the board is reset but the current values remain in the board.
How to reset the board
1. Press Menu on the remote control (RCU) or on the local keypad to activate the menus and select Alignment → Warp ing → . Warp
board reset .
Image 17-55
Warp board reset
2. Press ENTER to start the board reset.
17.7.23 Warp board and values reset
What can be done?
With some extreme warp values the hardware of the warping can get stuck. With only a hard reset of the board, it starts up with
the same extreme values and get stuck immediately. So that is not the solution. Therefore, while executing a hard reset, the warp
values are reset at the same time so that the board can start up.
How to reset board and values
1. Press Menu on the remote control (RCU) or on the local keypad to activate the menus and select Alignment → Warp ing → . Warp
board and values reset .
Image 17-56
Warp board and values reset
2. Press ENTER to reset the board and the current warp values.
R5906730 HDF WLP SERIES 01/08/2017 197