Barco HDF W series, Service Manual

Page: 268 / 337

15. Liquid cooling circuit
2
2
3
3
Image 15-42
Pump, removal
5. Install a new pump on the seating and fasten with two screws (reference 2), two rubbers reference 4), two washers (reference 5)
and two nuts (reference 3). Use a 3 mm Allen wrench to fasten the screws and a 7 mm open-end wrench to hold the nut while
fasten the screw.
Caution: Make sure that the pump is mounted upon two rubber vibration rings.
2
2
2
5
3
4
3
Image 15-43
Pump, mounting
6. Provide both hoses with a clip (reference 7 & 9) and push the hoses over their respective nipple of the pump house. Note that
the thick nipple (reference 6) is the input side of the pump house and has to be connected with the thick hose that comes from
the pressure vessel. The small nipple (reference 8) is the output side of the pump house and should be connected with the hose
that comes from the Light Processor.
7
6
9
8
Image 15-44
Hose connection
7. Slide the clip of both hoses over the connection. Use an universal pair of pliers to push both clip tongs to each other in order to
open the clip and to move the clip over the connection.
8. Reconnect the wire unit of the pump.
264 R5905312 HDF W SERIES 24/01/2013